AEG Powertools DSE 220l Gebrauchsanleitung Seite 4

Mains
connection
Switching on
and off
Electronics
Speed selection
Mounting the
base plate/
lamella base
plate
ENGLISH
Connect only to a single-phase AC current supply and only to the mains voltage
specified on the rating plate. Connection to sockets without earth protection is
possible as the appliance features protective insulation to DIN 57 740/ VDE 0740
and CEE 20. Radio suppression complies with the European standard EN 55014.
When fitting the plug, make sure that the brown (live) wire of this appliance is
connected to the plug terminal marked L or coloured red, and the blue (neutral) wire
of this appliance is connected to the plug terminal marked N or coloured black.
Under no circumstances must the wires of this appliance be connected to the earth
terminal of the plug marked either E, with the earth symbol, or coloured green or
green/yellow.
Switching on: Move the slide switch to the left in
direction of arrow. The switch engages.
Switching off: Depress "OFF" button of the slide
switch. The switch moves automatically back to
the 0-position.
Due to the electronic the speed can be controlled by setting the wheel to suit the
various materials.
The speed is adjusted by means of the electronic
thumb wheel.
1 = lowest r.p.m.
6 = largest r.p.m.
Always disconnect the plug from the socket before
carrying out any work on the machine.
Mount the base plate (turned approx. 15°) to the
tool reception (as shown in illustration) and turn it
in direction of arrow until it locks.
6
1
DSE 220, DSE 260