Power Tool Use; Cut-Off Wheels - Solo 879-14 Gebrauchsanweisung Und Originalbetriebsanleitung

Always observe all safety notes and all other information in all chapters of these operating
instructions for any work!
Check list for use (keywords only!) .................................................. Î
x Before start-up:
– Power tool in an operationally safe condition! ........................ Î Operating instructions complete
– Prescribed work clothes ......................................................... Î Chap. 3.3, page 7
– Working area inspected and secured ..................................... Î Chap. 3.2, page 6, and
– Correct cut-off wheel firmly installed. ..................................... Î Chap. 5.1, page 16, and
– Wheel guard in best position .................................................. Î Chap. 5.4, page 18
– Cutting device position, preferably centre position ................. Î Chap. 5.8, page 21
– Ribbed belt tension correct ..................................................... Î Chap. 5.6, page 20
– Tool properly fuelled ............................................................... Î Chap. 5.5, page 18
x Starting: ........................................................................................ Î Chap. 6 complete, page 24
x During work – generally safe work: .............................................. Î Operating instructions complete
– Check idle settings ................................................................. Î Chap. 8.3, page 31
– Inspecting the working situation ............................................. Î Chap. 3.9, page 10,
– Wet cutting preferred .............................................................. Î Chap. 5.7, page 20
– Secure working technique ...................................................... Î Chap. 7.3, page 27,
– Operating and maintenance notes complete .......................... Î Chap. 8 complete, as of page 29
Air filter clean .................................................................... Î Chap. 8.4, page 32
x After work: .................................................................................... Î Operating instructions complete
– Cleaning and care .................................................................. Î Chap. 8.1, page 29
– Secure storage of power tool ................................................. Î Chap. 8.11, page 38
– Maintenance ........................................................................... Î Operating instructions complete
7.1

Cut-off wheels

Only use cut-off wheels that correspond to the standards ANSI B7.1, EN 12413 and EN 13236 and
that are undamaged.
The maximum spindle speed of the power tool is 4,550 min
Only use high speed reinforced cut-off wheels marked with a permissible maximum operating speed
of at least 4,550 min
For processing of metals (hot cutting) and processing of mineral materials (cold cutting), different cut-off
wheels are offered. Only use cut-off wheels approved for the material being cut.
Diamond cut-off wheels are only approved for cutting mineral materials. When installing the diamond
cut-off wheel, always observe the rotating direction indicated on the diamond cut-off wheel; otherwise, the
cutting effect will reduce quickly from diamond loss.

7 Power tool use

-1
[4,550 rpm].
chap. 3.9, page 10
chap. 7.1, page 25
Chap. 7.2, page 26, and
Chap. 7.3, page 27
chap. 7.4, page 27, and
chap. 7.5, page 28
-1
[4,550 rpm].
Power tool use
ENGLISH 25