Warning, Instruction And Notice Icons - Solo 879-14 Gebrauchsanweisung Und Originalbetriebsanleitung

Important: If one or several icons in these operating instructions are centred and directly below a chapter
header the notice applies for the entire chapter.
Warning, instruction and notice icons used in the operating instructions and on the equipment:
Warning! Failure to comply with the instructions could cause accidents with potentially life-
threatening injuries.
Caution! Failure to comply with the instructions could result in damage to the equipment or other
material damage.
Carefully read the operating instructions. This applies before placing the equipment into
operation and before any cleaning, maintenance or assembly work.
Always wear the prescribed clothing. Î Chap. 3.3, page 7
Always wear sturdy shoes with good grip.
Wear safety gloves. This applies to all work with or on the equipment.
Choke flap:
Before starting the engine, put on hard hat, hearing protection, face shield and safety glasses.
Switch off the engine!
Smoking is prohibited anywhere near the power tool and in the location where it is refuelled!
Keep the power tool and fuel canisters away from open flames.
Warning: Danger of poisoning!
Warning: Kickback!
Notes in chap. 7.2 as of page 26 must be observed under all circumstances!
Warning: Danger of fire from sparks.
Wear breathing protection equipment.
Never use toothed circular saw blades.
Never use a damaged cut-off wheel.
Only use cut-off wheels approved for a speed of • 4,550 min
Noise level L
WA
Fuel tank Î Chap. 5.5, as of page 18

2 Warning, instruction and notice icons

Cold start position
Operation and warm start Î press the lever in
- The power tool generates exhaust gases.
- Petrol vapours are toxic.
- Dangerous dust emissions when working.
= 110 dB(A)
Warning, instruction and notice icons
Î pull the lever out
-1
[4,550 rpm].
ENGLISH 5