Dantherm HCH 5 Kurzanleitung Seite 7

How to replace the supply fan,
Procedure, continued
Step
4 Remove the styrene front
5 Disconnect the earth cables (placed
just in front of the print)
6 Cut the cable tie on the wire connection to the right of the print
7 Pull out the print a little bit.
Be carefull and do not pull hard on the cables or the print
8 Disconnect the two fan cables from the print
9 Pull out carefully the fan module from
the unit and place it on a table or the
like
10 Remove the 4 Torx 20 screws on the
back of the fan module
11 Remove cable tie inside the fan house
continued
Action
Continued overleaf
7