Checking The Battery Capacity - Parkside PAAL 6000 B2 Bedienungs- Und Sicherheitshinweise

The fuse of the car charger adaptor
be exchanged .
The technical data of the fuse must comply
with information given in the section
"Technical data" . The fuse may only be
replaced by a qualified electrician .
CAUTION! Do not connect the product to your
car's 12 V connection if the car battery is already
old and worn . Doing so could mean that the car
engine will no longer start .
NOTES:
In order to use the product without a
USB cable , you need to recharge the
[ 13 ]
rechargeable battery before use . The
charging process takes about 3 .5 hours . The
rechargeable battery is firmly integrated into
the base of the product .
Fully charge the rechargeable battery prior
to first use .
Charge the battery if it becomes empty
(only 1 LED of the charging indicator
flashing) .
Open the protective cap
Connect the USB cable
USB connector of the power adaptor
the car charger adaptor
Connect the USB plug (type C) of the
USB cable to the USB input socket
13 ] [
(type C) on the product .
9 ] [
Plug the power adaptor
or plug the car charger adaptor
12 V socket in your vehicle .
22 GB/IE
can
[ 12 ]
is
[ 6 ]
.
8 ] [
with the
13 ] [
or
11 ] [
.
[ 12 ]
into a socket,
[ 11 ]
into the
[ 12 ]
NOTES:
The battery charging status is shown by the
charging indicator
Charging indicator
status
1 LED flashes
1 LED lights up, 1 LED flashes
2 LEDs light up, 1 LED flashes
3 LEDs light up, 1 LED flashes 75‒100 %
4 LEDs light up
The charging time is approximately 3 .5 hours
when the battery was drained .
NOTE: The product has an overcharging
protection system . Nevertheless, you should
disconnect the product from the mains once the
charging process is complete .
Disconnect the USB cable
product to prevent the batteries discharging
themselves .
Close the protective cap
to use the product again . Otherwise water
could enter to the product when it is used
outdoors .
˜ Checking the battery capacity
When product is not charged: Press the battery
status button to check the battery capacity .
7 ] [
The green charging indicator
capacity* of the battery inside the product .
1 LED lights up = 25 %*
2 LEDs light up = 50 %*
3 LEDs light up = 75 %*
4 LEDs light up = 100 %*
* This is the approximate percentage of battery
capacity but not actual measurement .
:
6 ] [
Battery
6 ] [
charging
status
0‒25 %
25‒50 %
50‒75 %
100 %
from the
13 ] [
before you start
[ 8 ]
shows the
[ 6 ]