Use; Using The Product Without A Power Connection; Checking The Battery Capacity - Parkside PSDD 2000 A1 Bedienungs- Und Sicherheitshinweise

Charging indicator
status
2 LEDs light up, 1 LED
flashes
3 LEDs light up, 1 LED
flashes
4 LEDs light up
The charging time is approximately 4 – 5 hours when
the battery was drained.
Disconnect the USB cable
vent the batteries discharging themselves.
Close the protective cap before you start to use the
product again.

Use

Attach the product to an appropriate place.
Open the fixing wheel
Set the desired position of the magnetic foot.
Close the fixing wheel
The product may be secured with the hanging bracket
or by securing it to a flat, ferromagnetic surface
8
using the magnetic foot
Note: Pay attention to the weight of the product.
Using the product without
a power connection
Fully charge the product as described in the section
"Charging the product".
The product can be operated the dimming function by
controlled the ON / OFF wheel

Checking the battery capacity

The charging indicator
tery inside the product.
1 LED lights up = 25 %*
2 LEDs light up = 50 %*
3 LEDs light up = 75 %*
4 LEDs light up = 100 %*
Battery charging
1
status
50–75 %
75–100 %
100 %
from the product to pre-
10
by turning it anti-clockwise.
3
by turning it clockwise.
3
.
4
2
shows the capacity* of the bat-
1
(see Fig. C).
GB 11