Initial Operation; Inserting/Replacing Batteries; Operation; Working With The Automatic Leveller - Parkside PKLL 7 E4 Originalbetriebsanleitung

into contact with the skin,
you should rinse off this
area of the skin immedia-
tely under running water.
Make sure at all events that
your eyes and mouth do not
come into contact with the
liquid. If they do, seek me-
dical advice immediately.
Clean the battery contacts
•
and the equivalent contacts
in the device before inser-
ting the batteries.

Initial Operation

Inserting/replacing
batteries
1. Open the battery com-
partment (3).
2. Insert two AAA batteries.
Ensure you place the bat-
teries into the compart-
ment in accordance with
the illustration.
3. Close the battery com-
partment (3).
The LED ring (2) will flash
red when the battery
charge is low.

Operation

Caution! - Laser beam.
Do not look into the
beam. Turn your head away
or close your eyes to prevent
looking into the laser beam.
Danger of eye injury!
Working with the
automatic leveller
1. Place the device on a
horizontal solid surface.
The on/off switch (1) must
be pointing upwards.
Or fasten the device to a
tripod (see "Working with
the clamp tripod" / "Wor-
king with the tripod").
2. Align the device so it is
parallel with the floor
3. Switch the device on by
releasing the levelling
stop: position
The LED ring (2) will illu-
minate:
Green: if automatic le-
velling is possible.
Levelling is complete
once the laser lines no
longer move.
GB IE
.
9