Parkside PPSK 40 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 11

Risk of electric shock:
WARNING!
 Electric shock from the cutting
electrode can be fatal.
Do not use the plasma cutter

when it is raining or snowing.
Wear dry insulating gloves.

Do not touch the electrodes

with bare hands.
Do not wear wet or damaged

gloves.
Protect yourself from electric

shock with insulation against
the workpiece.
Do not open the device

housing.
Additional protection against a

shock from the mains power in
the event a fault can be pro-
vided by using a fault-circuit
interrupter, which is operated
with a leakage current of no
more than 30 mA and covers
all mains-powered devices in
close proximity. The fault-circuit
interrupter must be suitable for
all types of current.
There must be means of rapid

electrical isolation of the
cutting power source or the
cutting circuit (e.g. emergency
stop device) which are easily
accessible.
Danger from smoke
emission when plasma
cutting:
Inhalation of fumes which

result from plasma cutting can
endanger health.
Do not keep your head in the

fumes.
Use the device in open areas.

Only use the device in

well-ventilated spaces.
Danger from fl ying sparks
when plasma cutting:
Cutting sparks can cause an

explosion or fi re.
Keep fl ammable substances

away from the cutting location.
Do not use the plasma cutter

near fl ammable substances.
Cutting sparks can cause fi res.

Keep a fi re extinguisher close

by and an observer should
be present to be able to use it
immediately.
Do not carry out plasma

cutting on drums or any other
closed containers.
Danger from arc beams:
Arc beams can damage your

eyes and injure your skin.
Wear a hat and safety

goggles.
Wear hearing protection and

high, closed shirt collars.
GB/IE/NI/CY/MT
Safety instructions
11