Troubleshooting; Technical Data; General Nebuliser Data - Pari LC PLUS 022 Gebrauchsanweisung

6

TROUBLESHOOTING

Contact the manufacturer or distributor:
– in the event of faults that are not listed in this chapter
– if the suggested procedure does not correct the fault
Fault
No aerosol is
coming out of
the nebuliser.
7

TECHNICAL DATA

7.1 General nebuliser data

5
Size
5
Weight
Operating gases
Minimum compressor flow
Minimum operating pressure
Maximum compressor flow
Maximum operating pressure
Minimum fill volume
Maximum fill volume
5) Without mouthpiece; unfilled.
– 39 –
Possible cause
The nebuliser nozzle
is blocked.
The connection
tubing is not connec-
ted properly.
The connection
tubing is leaking.
Remedy
Clean the nebuliser.
Check that the tubing con-
nectors are connected firmly
to the compressor and the
nebuliser.
Replace the connection
tubing.
10 cm × 9.5 cm × 4.5 cm
27.5 g to 29.5 g
Air, oxygen
3.0 l/min.
0.5 bar/50 kPa
6.0 l/min.
2.0 bar/200 kPa
2 ml
8 ml