Electrical Connections - WIKA CPH 6200 Betriebsanleitung

Hand-Held Pressure Indicator
CPH 6200 / CPH 6200-D / CPH 6200-Ex
holding the plug by the cable strain relief, rather than by the
connector housing. If the plug is correctly located, it will slide in
smoothly. To disconnect the sensor hold it by the plug to release
the connector lock. Do not pull the cable to release it.
For gauge sensors, the pressure compensation vent hole is
found at the top of the sensor housing. This vent (with integral
membrane seal) must be kept clear without fail.
Maintenance advice
Both the CPH 6200 and sensors are manufactured using solid-
state technology, and contain no moving parts which could
wear. If the instrument housing has been opened, the warranty
becomes invalid.
If cleaning is necessary, use a cloth wetted with mild detergent.
Avoid any solvents, caustic or abrasive substances.
As is normal for all measuring instruments, the accuracy of the
device should be tested at regular intervals (approx. once per year
- see Section 9).

1.3 Electrical Connections

On the upper edge of the device:
The connector sockets for attaching the CPH series pressure
sensors, CH1 and CH2 (CH2 only with the 2-channel version), are
located on the top edge of the CPH 6200 (see Section 6), as is the
socket for the serial interface adapter (see Section 5).
On the left side of the device:
The mains adapter socket for connecting the power supply unit
(see current CPH 6200 price list) is located on the left side of the
handheld unit.
WIKA Operating Instructions Hand-Held Pressure Indicator
CH1 CH2 (only for 2-channel version: CPH 6200-D)
Connection for serial
interface adapter
GB
7