WIKA CPH 6200 Betriebsanleitung Seite 16

Hand-Held Pressure Indicator
CPH 6200 / CPH 6200-D / CPH 6200-Ex
GB
16
Max. number of measurements:
The data recorded includes the following values:
Sensor 1 instantaneous value at that data point
Sensor 1 Min-Peak, Max-Peak since last data point
Sensor 2* instantaneous value at that data point
Sensor 2* Min-Peak, Max-Peak since last data point
Instantaneous difference (Sensor 1 - Sensor 2)* at that data point
Min-Peak, Max-Peak of the difference (Sensor 1 - Sensor 2)*,
Min-Peak, Max-Peak since last data point
Time and date stamp of that data point
* Only for 2-channel version CPH 6200-D
After each recording "St. XX" will be displayed for a short time. XX
represents the number of the data point.
If the logger memory already contains data:
When the ´Store/Quit´ key is pressed for 2 seconds, the option to
clear the logger memory will be displayed:
clear
all data points
clear the last
data point
Use the 'Min' or the 'Max' key to display the required option. The
´Store/Quit´ key selects that choice.
If the logger memory is full, the display will show:
Viewing Recorded Measurements
Within the "LoGG Stor" function the measurements can be viewed
directly on the instrument display as well as through a computer
("Func CYCL" only allows for the data to be viewed on computer).
Press the ´Set/Menu´ key for 2 seconds: The first menu displayed
is now "rEAd LoGG" (read logger data). By then pressing the ´Tara´
key, the last measurement recorded will be displayed; pressing the
´Tara´ key again scrolls between the different values related to this
data point.
Pressing the ´Min´ key or ´Max´ key selects different data points.
WIKA Operating Instructions Hand-Held Pressure Indicator
99
clear nothing
(cancel menu)