Package Contents; Electrical Safety - DeWalt DC413 Anleitung

disc causing an uncontrolled cut-off tool to
lift up and out of the workpiece toward the
operator.
• When the wheel is pinched or bound tightly by
the workpiece, the wheel stalls and the motor
reaction drives the unit rapidly back toward or
away from the operator.
• Kickback is the result of tool misuse and/or
incorrect operating procedures or conditions
and can be avoided by taking proper
precautions as given below:
• Maintain a firm grip with both hands on the
unit and position your body and arm to allow
you to resist kickback forces. Kickback forces
can be controlled by the operator, if proper
precautions are taken.
• When wheel is binding, or when interrupting
a cut for any reason, release the trigger and
hold the unit motionless in the material until
the wheel comes to a complete stop. Never
attempt to remove the unit from the work
or pull the unit backward while the wheel is
in motion or kickback may occur. Investigate
and take corrective actions to eliminate the
cause of wheel binding.
• When restarting a cut-off tool in the
workpiece, check that the wheel is not
engaged into the material. If wheel is binding,
it may walk up or kickback from the workpiece
as the tool is restarted.
• Support large panels to minimize the risk of
wheel pinching and kickback. Large panels
tend to sag under their own weight. Support
must be placed under the panel on both sides,
near the line of cut and near the edge of the
panel.

Package contents

The package contains:
1 Angle grinder
1 Type 27 guard
1 Anti vibration side handle
1 Flange set
1 Two-pin spanner
2 Battery packs (DC413KL/DC415KL)
1 Battery charger (DC413KL/DC415KL)
1 Kit box (DC413KL/DC415KL)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
INTENDED USE
Your DC413/DC415 grinders are designed for
professional applications. DO NOT use under humid
conditions or in presence of flammable liquids or
gases.
DO NOT use grinding wheels other than center
depressed wheels and flap-disc.
These heavy-duty angle grinders are professional
power tools. DO NOT let children come into
contact with the tool. Supervision is required when
inexperienced operators use this tool.
a. Trigger switch
b. Lock-Off Button
c. Spindle lock button
d. Side handle
e. Abrasive wheel
f. Anti-lockup backing flange
g. Threaded clamp nut
h. Type 27 guard
i. Battery pack
j. Battery release button
Charger
Your DE9000 charger accepts D
Li-Ion battery packs of 36 V (DE9360) and
28 V (DE9280) at 2.2 Ah.

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335.
EN GL IS H
WALT
E
35