Locking The Dosing Pumps; Manual Control - Aquacontrol CL2 Deluxe 2,4 l/h Bedienungsanleitung

PAGE 33
6. Locking the dosing pumps - clearing the lock
Press the "Mode" button once to enter set-up
mode. „Stop control unit" appears in the dis-
play. Now press the „OK" key.
The control unit springs back into operating
mode. The dosing pumps are now locked.
„Stopped" appears repeatedly in the display. No
chemicals are added to the pool water. Measure-

7. Manual control

The manual control enables intervention in the
dosing of pH and disinfectants. This function is
especially suited to commencing operation of
the measuring, control and dosing unit.
Keep the „OK" key pressed for a couple of sec-
onds. After releasing the „OK" key the "Manual
control" menu appears. You can choose be-
tween manual control „pH" and "Disinfection"
using the arrow keys.
Caution: Cancel using the „Mode" key.
Pressing the "OK" key activates manual control
for the selected area.
Manual control „pH":
If the „pH" manual control is triggered,
„Manual control" appears in the display. The
pH dosing pump works at full performance.
Manual control „Disinfection"
If the „Disinfection" manual control is trig-
gered, „Manual control" appears in the display.
The pH dosing pump works at full perfor-
mance. The manual control is terminated by
ment of pH and ORP value are continued.
Press the „OK" key briefly to unlock the dosing
pumps. The control unit is again in operating
mode.
briefly pressing the "Mode" key or by reaching
the desired setpoint.
Caution: As the dosing pump works at full per-
formance (100%) until it reaches the setpoint,
this can lead to overdosing.
Reason: When a water treatment product is pumped
into the nozzle pipe, depending on the pool hydrau-
lics, there can be a time delay before the water with
treatment product reaches the measuring cells again.