Mode 2: Limit Switch Setting (Semi-Automatic) - cherubini BLUE TRONIC RX-Serie Einstellanleitungen

mode 2: limiT SwiTch SeTTing (semi-automatic)

To do the settings in this mode the rolling shutter has to be equipped with lockdown
hangers in the closing position, but the rolling shutter does not need to have physical
stops in the opening position. This mode of setting is helpful in cases where the factory
will set the opening position and the closing position will be set automatically during
the normal use.
in this mode, it's necessary to set first the opening position!! (rolling shutter
open!)
SETTInG THE OpEnInG pOSITIOn
press button A or C and drive to the opening position.
with physical stops: press button A or C until the motor stops automatically.
without physical stops: use buttons A and C to drive to the necessary opening position.
if the shutter is already completely open, you have to first drive down by about
20 cm.
To set the opening position, press button (stop) for about 2 seconds, until the motor
performs a short downwards movement.
now the drive direction is detected and the motor can be disconnected from the power.
The closing position will be set automatically during the normal use. when the motor
is powered up again, the remote control can be used normally. The lower limit switch
position will be set automatically the first time the rolling shutter stops automatically in
the closing position using the lock down hangers. As the motor looks for a "mechanical"
stop during each way down, if the Obstacle Recognition finds something is blocking the
way (such as a protruding screw in the guide rails), it is necessary to raise the shutter
again, remove the obstacle and to drive the motor back to the closing position to set
the limit.
Tn: Already programmed remote control
A
B
?
Tn (2 sec) confirm
C
I
33