Special Functions; Short-Term Setting Of A Remote Control - cherubini BLUE TRONIC RX-Serie Einstellanleitungen

Special funcTionS

SHORT-TERM SETTInG OF A REMOTE COnTROL

This function makes it possible to store a remote control temporarily, for example, with
the purpose of setting the limit switches during assembly in the factory. A later final
saving of the remote control will be possible using the appropriate command sequence
(see: "SETTInG THE FIRST REMOTE COnTROL").
The operations described below can be carried out only when the motor has just come
out of the factory or after a full memory clearing (see: "FULL MEMORy CLEARInG"). The
motor makes the following operations possible only within the time limits described in
order to make sure that the shor-term setting is used only in the installation or regulation
phase and not during daily use.
Feed the motor, make sure that no other motors having an empty memory are being fed
in the same operating range.
within 30 seconds after start, press the B and C buttons simultaneously until the
motor gives a confirmation signal.
The remote control will remain stored for 5 minutes, while the motor is being fed.
After 5 minutes or when no voltage is supplied to the motor, the remote control will be
cancelled.
T1: remote control to be stored
B C
+
T1
38