Command Sequences - cherubini BLUE TRONIC RX-Serie Einstellanleitungen

Most of the command sequences have three distinct steps, at the end of which the motor
indicates if the step has been concluded positively or not, by turning in different ways.
This paragraph is provided to recognise the motor indications. The buttons must be pressed
as shown in the sequence, without taking more then 4 seconds between one step and the
next. If more then 4 seconds are taken, the command is not accepted and the
sequence must be repeated.
Command sequence example:
A
+ B
Step 1
As we can see from the example, when the sequence ends positively, the motor returns to
its starting position in one long rotation. In fact, two short rotations in the same direction
correspond to one long rotation in the opposite direction. The motor returns to the starting
position even when the sequence is not completed; in this case by performing one or two
short rotations.
Example of a wrong sequence:
A
+ B
Step 1
A
+ B
Step 1
I

command SeQuenceS

B
Step 2
4 sec
B
Step 2
29
B
Step 3
repeat the
sequence
4 sec
repeat the
sequence