capital sports Helios Bedienungsanleitung Seite 33

EN
Unscrew the 4 self-tapping screws (18) which are pre-installed on the two
pedals (17 L/R). Attach the left pedal (17 L) to the left bracket of the pedal
support tube (12). Secure it with 2 self-tapping screws (18). Repeat the
same steps for the right pedal (17 R). Fit the entire pedal support tube (12)
in the centre of the main frame (1). Secure this with 2 carriage bolts (16), 2
washers (14) and 2 cap nuts (15).
Note: Make sure that the pedals (17 L/R) are attached to the pedal support
tube (12) before installing the pedal support tube (12) on the main frame
(1).
4
Unscrew 1 set of washers (14), nylon nuts (23) and Allen screws (31) pre-mounted on the main
frame. Pull the ball pin (32) out of the main frame.
Push the guide rail tube (6) onto the U-shaped connecting tube of the main frame. Secure this
with 1 washer (14), 1 nylon nut (23), 1 Allen screw (31), 1 washer (58) and 1 knob (33).
First remove 2 sets of Allen screws (9) and rubber dampers (10) from the end of the guide rail
tube (6). Slide the saddle (22) onto the guide rail tube (6). Reattach 2 damping rubbers (10) to
both sides of the guide rail tube (6) and align them with the holes. Secure it with 2 Allen screws
(9). Fit the end caps (28 & 29) to the back of the guide rail tube (6).
33