Cleaning And Greasing; Greasing The Cassette Seal - Dometic CT4050 Bedienungsanleitung

CT(E), CTLP, CT(E)S, CTW
8

Cleaning and greasing

A
NOTICE! Damage hazard
• Cleaning agents for the toilet may not contain chlorine or alcohol.
• To prevent material changes, do not use hard, abrasive or
soda-based cleaning agents (scouring agents).
• Do not use polish for cleaning.
➤ Clean and grease all seals on the toilet and cassette tank regularly. In case of fre-
quent use, perform these actions monthly or after 3 – 5 drainings of the cassette.
Use grease or silicone-based spray.
The manufacturer recommends:
– Grease: OKS
– Silicone spray: OKS
➤ Clean the toilet regularly inside and out with a soft cloth and lukewarm water with
a mild colorless cleaning agent. Then wash the surfaces with clear water.
8.1 Greasing the slider rods
!
CAUTION! Risk of crushing
When the slider is closed during cleaning or greasing, there is a risk of
crushing body parts (fig. b, page 8).
The slider moves smoothly when it is regularly lubricated.
➤ Spray the slider rods with silicone spray (fig. c, page 9).
8.2

Greasing the cassette seal

1. Remove the cassette tank and place it on a firm surface (fig. d, page 9).
2. Unlatch the slider handle and pull it out (fig. e, page 9).
3. Turn the slider anti-clockwise and release it from the cassette (fig. f, page 10).
4. Push back the cover so that the seal is accessible (fig. g, page 10).
5. Clean and grease the seal.
!
CAUTION! Risk of crushing
Do not reach into the opening when you close the cover.
6. Close the cover (fig. k, page 11).
7. Place the slider back on.
EN
®
1110
®
1111
Cleaning and greasing
25