EN
54
Replacing the LED lighting
•
Switch off the device immediately and pull the power plug out of the socket.
•
Let the lighting cool down before replacing it.
•
Locate the position of the lamp holders.
(On some models you have to remove the grease filters to find the lamp
holders. On some other models, the lamp holders are concealed by the light
panel. Unscrew the light panel before replacing it)
•
Loosen the screws on the LED board and brackets, disconnect the light wiring
and carefully insert the new lamp.
Illustration for the screws/cabling of the LED light strip
Note: Be sure to reassemble everything after replacing the lamp and fix all
screws in the same position.
Note: Always replace the lamp with a lamp of the same type and amperage.