Installation - Klarstein LIMELIGHT 120 Bedienungsanleitung

EN
36

INSTALLATION

Important information before installing the appliance
• Clean the surrounding area thoroughly before and after installation so that no
dust or construction debris can be sucked in during commissioning.
• Only place the appliance in a suitable location.
• Check the wall for load-bearing capacity.
• Check the routing of electrical and other cables on and in the wall or ceiling to
ensure that they are not drilled into.
• Check the condition and load-bearing capacity of the electrical cables.
• Installation of the unit by a specialist is recommended.
• During installation, strictly observe the minimum distance between the hob
and extractor hood and follow the description of the work steps under "Wall
Installation" and all other instructions.
In the version with exhaust air to the outside, the vapours are extracted via an
exhaust air hose attached to the connection ring.
• The diameter of the exhaust air hose must correspond to the diameter of the
connection ring.
• The exhaust air hose must not be routed through a shaft together with gas
pipes, hot air pipes etc.
• The exhaust air hose must be routed away from the hood in as straight a way
as possible; the maximum permissible outward bend is 120°.
• If a flue gas non-return flap is used or is planned, it must be checked to see
whether it can open and close freely after the exhaust air hose has been
installed.
• The cooker hood can be equipped with one (top) or two (top and rear) exhaust
openings.
• As a rule, the hood is initially equipped for use of the upper extractor opening
as a cooker hood.
• The openings that are not needed are covered with a plastic cover. This
plastic cover can be easily removed by turning it anticlockwise and optionally
attached to another opening that is not needed.
Use of the cooker hood as an exhaust hood
(for exhaust air operation into the open air)
If the cooker hood is equipped with an activated carbon filter at the factory, this
must be removed for exhaust air operation. This use only makes sense if you
operate your cooker hood in recirculation mode.