Abicor Binzel ABIROB W300 Betriebsanleitung Seite 43

®
ABIROB W
Fault
Pore formation
Tab. 8
Troubleshooting
11 Dismounting
Cause
• Strong spattering in the gas nozzle
• Insufficient or lack of gas coverage
• Air currents blowing shielding gas
away
Dismounting may only be carried out by specialized personnel. Please make
sure that the shutdown procedures are strictly observed before the dismounting
work begins. Ensure this also for the components integrated into the welding
system.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Close off the compressed air supply.
• Switch off the entire welding system.
• Disconnect all electrical connections.
NOTICE
• Observe the information given in section 8 Putting out of operation on
page EN-16.
1 Disconnect the cable assembly from the wire feeder.
2 Remove the parts to be disconnected (changeable body, mount, CAT robot
mount, torch neck).
11 Dismounting
Solution
• Clean gas nozzle
• Check gas cylinder contents
and pressure setting
• Shield welding area with
partitions
EN - 21