Cleaning And Maintenance; Storage; Disposal And Recycling - Scheppach CGP1200 Original Bedienungsanleitung

15. Cleaning and maintenance

m WARNING!
Switch off the device and pull out the mains plug before
carrying out any work on the device.
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub
the device clean with a clean cloth or blow it off with
compressed air at low pressure.
• We recommend that you clean the device directly
after every use.
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior. Water entering a power
tool will increase the risk of electric shock.
The device has no further internal parts that require
maintenance.
Empty dust bag
To ensure optimum dust extraction, empty the dust bag
(18) in good time.
• Open the zip of the dust bag (18).
• Shake out the dust bag (18) over a suitable waste
container.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Carbon brushes, switch
* may not be included in the scope of supply!
Connections and repairs
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any queries:
• Type of current for the motor
• Data of machine type plate
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

16. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the power tool in its original packaging. Cover the
power tool to protect it from dust or moisture. Store the
operating manual with the power tool.

17. Disposal and recycling

The device is supplied in packaging to avoid
transport damages. This packaging is raw ma-
terial and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and plas-
tics. Take defective components to special waste dis-
posal sites. Check with your specialist dealer or munic-
ipal administration!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised collec-
tion point for the recycling of old electrical and electron-
ic devices. Improper handling of waste equipment may
have negative consequences for the environment and
human health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natural re-
sources. You can obtain information on collection
points for waste equipment from your municipal admin-
istration, public waste disposal authority, an authorised
body for the disposal of waste electrical and electronic
equipment or your waste disposal company.
www.scheppach.com GB | 33