Unpacking; Before Commissioning - Scheppach DH1600Max Original Bedienungsanleitung

Wear hearing protection.
Excessive noise can result in a loss of hearing.
Total vibration emission values (vector sum of three
directions) determined according to EN 60745.
Main handle
Hammer drills in concrete:
a = 18.987 m/s , K = 1.5 m/s
2
h(HD)
Additional grip
Hammer drills in concrete:
a = 18.987 m/s , K = 1.5 m/s
2
h(HD)
Main handle
Chiselling: a = 19.962 m/s
h(CHeq)
Additional grip
Chiselling: a = 19.962 m/s
h(CHeq)
The specified vibration emission value has been meas-
ured according to a standardised testing procedure
and can be used for comparison of one power tool with
another; and may change depending on the way in
which the power tool is used and in exceptional cases
may be higher than the specified value.
The specified vibration emission value can be used to
compare one power tool with another.
The specified vibration emission value can also be
used for an initial estimation of the impair.
Keep the noise level and vibration to a minimum!
• Only use devices which are free of defects.
• Maintain and clean the device at regular intervals.
• Adapt your working methods to the device.
• Do not overload the device.
• Have the device checked if necessary.
• Switch the device off if it is not in use.
• Wear gloves.
7.

Unpacking

• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
2
2
, K = 1.5 m/s
2 2
, K = 1.5 m/s
2 2
www.scheppach.com
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating instructions before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
m WARNING!
The device and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!

8. Before commissioning

Before connecting the machine, make certain that the
data on the type plate matches with the mains power
data.
Warning!
Always pull out the mains plug before carrying out
adjustments on the device.
Check the deployment location for hidden electrical
lines, gas pipes and water pipes using a cable detector.
Additional grip (Fig. 1)
For safety reasons, only use the hammer drill with
the additional grip.
The additional handle (9) allows the user additional
hold when using the hammer drill. For safety reasons,
it is not permitted to use the device without the addi-
tional handle (9). The additional handle (9) is fastened
to the hammer drill by clamping. Turning the handle
anti-clockwise (as seen from the handle) looses the
clamping. Turning the handle clockwise tightens the
clamping. First, loosen the clamping of the additional
handle. You can subsequently swivel the additional
handle (9) into the working position that is most com-
fortable for you. Now turn the additional handle back
in the opposite direction of rotation until the additional
handle is firmly seated.
GB | 21