Carbon Filter; Emptying The Litter-Robot - whisker litter robot 4 Bedienungsanleitung

Carbon Filter

The Litter-Robot is equipped with a flexible Carbon Filter pad
that is installed on the outer bottom area of the Globe. This
filter sits directly over the Waste Drawer to absorb odours.
The Carbon Filter is easily removed and installed
by starting a Clean Cycle, then opening the Bonnet
when the Globe is at the Dump Position. Replace
the Carbon Filter as needed. Under normal use,
one filter should last approximately 1 month. The
Carbon Filter is not required for the unit to function.
Replacement Carbon Filters and other odour-absorbing
accessories can be ordered at litter-robot.com.
Base Seal Strips
The Litter-Robot is equipped with brush-type Seal Strips
on both the top and bottom of the Base.
These Seal Strips help contain odours within the
Waste Drawer.
Replace the Seal Strips when you notice they are
worn flat or peeling up. Make Seal Strips last longer by
trimming loose edges between replacements. Be careful
not to get them wet when cleaning the Base or they may
begin to peel. Replacement Seal Strips can be ordered at
litter-robot.com.

Emptying the Litter-Robot

1.
Press the Empty button to cycle the Globe clockwise, which will allow
the litter to fall through the Waste Port and into the Waste Drawer for easy
disposal.
2.
If litter remains in the Globe, sweep the granules toward the Waste Port.
3.
Press any button to return the Globe to the Home position.
IMPORTANT: Supervise and prevent your cat from entering during the Empty cycle,
as the unit may not detect your cat without litter in it.
30
www.whiskersupport.com
Carbon
Filter
Seal
Strips