Setting Up Your Litter-Robot - whisker litter robot 4 Bedienungsanleitung

Setting Up Your Litter-Robot

Your Litter-Robot comes fully assembled and ready to use. Get started by following
the steps below.
Placement
‰ If possible, place the Litter-Robot in the same location as the old litter box (at least
during transition).
‰ Make sure the unit is on a firm, level surface. Avoid soft, uneven, or unstable flooring.
‰ Keep the unit indoors in a cool, dry location. Reduce exposure to high temperature
and humidity. If possible, keep out of direct sunlight.
Place the unit near a power outlet. Ensure the unit isn't pushed against a wall or into a
‰
corner (must not be touching any walls).
‰ Place litter mats or rugs in front of, or completely under, the unit. Do not place mats
partially under the unit. Use only low pile 6 mm rugs and mats under the unit.
DO NOT use litters that are the strictly absorbent, non-clumping, loose-clumping,
newspaper-based, or wood-based pellets.
Litter
Fill the Globe through the circular opening
with clumping litter until it meets the
raised MAX Fill Line when spread flat—
approximately 3.6-4.5 kg by weight or 4L by
volume. Be careful not to overfill the Globe.
The Litter-Robot litter sifting system requires
clumping litter to work properly. We
recommend a high-quality, clay-clumping
litter. Litter beads and crystals that are small
enough to pass through the screen will also
work (periodic changing of this type of litter
is required).
12
www.whiskersupport.com
Litter
Fill line