Ongoing Maintenance - whisker litter robot 4 Bedienungsanleitung

15

Ongoing Maintenance

Empty the Waste Drawer when indicated by the Light Bar flashing blue on the Control Panel.
How often you will need to empty the Waste Drawer depends on the number and size of your
cats. For two average-sized cats, twice per week is typical. For a single cat, once per week is
usually sufficient.
Pull out the Waste Drawer, gather the edges of the liner bag, and dispose.You can use
Litter-Robot custom-fit Waste Drawer Liners or any 37-49L trash bags.
To install a new Waste Drawer Liner, open the bag and wrap the opening over the perimeter of
the Waste Drawer flange. Push the remainder of the bag into the bottom of the Waste Drawer.
Slide the drawer back in, being careful not to push the unit against the wall or into a corner
(should not be touching any walls for accurate weight measurements). Then, press the Reset
button to zero the Weight Sensors.
Waste Drawer Liner Is
Inserted Here
Waste
Drawer
Add litter as needed.
Check the litter level once per week or each time you empty the Waste Drawer. Add just
enough litter to meet the raised MAX Fill Line inside the Globe, and be careful not to overfill
it to avoid wasting litter. After adding or removing litter, press the Reset button to zero the
Weight Sensors.
Press the Reset button.
Any time you affect the weight or placement of the unit (including emptying the Waste
Drawer, adding or removing litter, or cleaning or moving the unit), press the Reset butt on to
ensure the Weight Sensors will detect your cat and cycle properly.
See Use and Care on page 29 to learn about the Carbon Filter, Base Seal Strips, Waste Drawer
Liners, and how to clean the Litter-Robot.
www.whiskersupport.com