Control Panel - Button Functions; Power Button; Cycle Button - whisker litter robot 4 Bedienungsanleitung

Control Panel - Button Functions

Power Button

Press the Power button to turn the unit power ON or OFF. When turning the unit ON, the Light
Bar will flash white, then the unit will perform a Clean cycle with a sequential round robin
yellow Light Bar indicating the direction of rotation.
With the unit powered ON, a 3-second long press of the Power button will turn the unit OFF.
Cycle Button + (8-Hour Sleep Mode)
Press the Cycle button to start a Clean cycle (see page 16). Press the Cycle button again to
pause or resume the cycle.
A 3-second long press will activate the default 8-Hour Sleep Mode (see page 24). The Light
Bar will change to purple, indicating Sleep Mode is enabled for the next 8 hours. To exit this
mode, press and hold the Cycle button for 3 seconds. The Light Bar will change to blue,
indicating the mode has been disabled.
Power Cycle
www.whiskersupport.com
18
Reset
Empty Connect
Light Bar