Empty Cycle - whisker litter robot 4 Bedienungsanleitung

If your cat re-enters the Globe during the Wait Time countdown (red Light Bar on), the Cat
Sensor(s) detect that your cat has entered and will not cycle with your cat inside (see page
21). Once your cat exits, a new countdown will begin.

Empty Cycle

The Empty cycle allows you to empty all of the litter from the Globe into the Waste Drawer
for easy disposal. Use this cycle to change out the entire litter bed or before cleaning the
Globe (see page 31).
While the Globe is in Home position with the blue Light Bar on, press the Empty button to start
an Empty cycle.
During an Empty cycle, press the Cycle, Reset, Empty, or Connect button to pause the cycle.
Press the Cycle button to resume the cycle. Press the Reset button to abort the cycle and
return the Globe to the Home position.
How it works:
1.
Upon pressing the Empty button, the Globe rotates clockwise with the
sequential round robin yellow Light Bar indicating the rotational direction.
2.
As the Globe rotates clockwise, litter will fall through the Waste Port and into the
Waste Drawer.
3.
After the litter is emptied, the Globe pauses with the yellow Light Bar on and awaits
your action. (You may need to sweep any remaining litter toward the Waste Port.)
4.
Press the Cycle or Reset button to return the Globe to the Home position.
IMPORTANT: Supervise and prevent your cat from entering during the Empty Cycle.
17
www.whiskersupport.com