Connection Between The Monitor And The Intercom Panel - avidsen 340100 Bedienungsanleitung

Between the monitor and the intercom panel (100m maximum)
To ensure good audio and video quality, it is recommended to not use more than 100m of cable between the
intercom and the intercom panel. Connect the wires as follows (incorrect wiring can damage the intercom
panel).
The cable's length determines which cable section is to be used:
Cable length
0 to 50 m
50 m to 100 m
Between the intercom panel and an electric strike plate (not included)
Use a 12V/1.1A maximum electric latch with or without mechanical memory.
For the connection between the intercom panel and the door release, use a cable of this kind:
Cable length
0 to 50 m
Between the intercom panel and the automated gate (not included)
Section to use: Min. 0.75 mm

3.1 - CONNECTION BETWEEN THE MONITOR AND THE INTERCOM PANEL

IMPORTANT: connect gate control output directly to the opening/closing contact of the automatic control
system (automated entryway wired control system input).
Your gate video intercom system is equipped with the Polarity Protect feature: you can connect the 2 wires
for the monitor, electric strike plate and gate in any direction.
2
Monitor
COLOUR VIDEO INTERCOM 7"
C - INSTALLATION
Section to use
0.75 mm
2
1.5 mm
2
Section to use
0.75 mm
2
Intercom panel
EN
7