Functional Description; Searching The Satellite; Back To Home Position & Turning Off - SELFSAT SNIPE BT Grey Line Bedienungsanleitung

※ Get ready to use
Default is set Automatic mode;
both dip switches are up.
Customers should use only in
Automatic mode.
If the switch is handled in other
than the Automatic mode, the
unit does not operate normally.
Warning
Mode selector is for A/S, so it is not recommended by consumers to modify it arbitrarily.
Consumers should never do this, and if trouble is occurred in Manual mode, guarantee
will not be provided.

4-1. Searching the satellite

a. When the controller is turned on, some LEDs light indicate firmware version
(It is made by binary code and for future service purpose)
b. Once the unit is ready to use, one of satellite LED is lit ON at default satellite
c. Go to the target satellite using arrows buttons and press SET button to confirm
d. Before satellite search, HOME LED blinks for antenna status(position) check
(If antenna was not at HOME, antenna has to return to HOME first, LED may blink for a while)
e. Lock LED blinks during satellite search and becomes solid when the target satellite is found
f. After use and before travelling, press HOME button for HOME positioning
4-2. Back to HOME position & Turning off
A. Automatic
In some cases, the antenna is automatically stopped and sent to HOME position
a. If ignition cable is connected and ignition signal is detected

4. Functional description

antenna position check
searching satellite (●)/ found (●)
firmware ver. (Binary code)
ENGLISH - 8
(● ●
)
Automatic mode
Manual mode