5-1. Power turn on & off
a.
Turn on the backside power switch of the controller
b.
Press the power button to turn on / off
c.
When the backside power switch is on, operation can be adjusted by RF remote control
5-2. Searching the satellite
All satellite LEDs blink and then system is displayed like below image
a.
When the controller is turned on, some LEDs light indicate firmware version
(It is made by binary code and for future service purpose)
b.
Once the product is ready to use, three LEDs of satellite are lit ON at default satellite
c.
Go to the target satellite using arrow buttons and press SET button to confirm
d.
During satellite search, Search LED is on for antenna status
e.
Lock LED becomes solid when the target satellite is found
f.
DiSEqC LED Default is OFF (Default setting for DiSEqC is OFF)
5. Functional description
Search LED : Searching satellite (●) / Found(○)
Lock LED : target satellite found (●) / not found(○)
DiSEqC LED : DiSEqC On(●) / Off(○)
firmware ver. (Binary code)
ENGLISH - 10
Mute button : Alarm buzzer off