SELFSAT SNIPE BT Grey Line Bedienungsanleitung Seite 21

D. Fix mounting plate with 8 pcs of M6x15 bolt using allen wrench
D-1
Parts required, allen wrench and eight(8) of
M6×15 bolt
E. Cable holder installation 1
E-1
Place cable out from the antenna to have a rough idea of cable holder location (approx. 40~45cm
away from the antenna port) and apply masking tape 5mm way off from the outside of holder
E-2
Drill a 25mm hole in the center of the tape
marking
Place the antenna on mounting plate and
tighten firmly each bolt by allen wrench
approx. 40~45cm
Make sure that hole size is minimum so that the
cable can pass through
ENGLISH - 19
D-2
E-3