Functional Description - SELFSAT SNIPE Bedienungsanleitung

3-2. Functional Description

A. Power On
Function
Home position means antenna folded completely to the body part that is basic position for carrying in hard
◆
case or mounting on the car.
B. Selecting the satellite
Function
C. Searching the satellite
Function
8
Description
"Power" Switch
"Home State"
Light Solid ON
"Home State"
Light Solid ON
Solid ON
Description
"Satellite
Up / Down button" Light
"OK" Button
Description
"Satellite" light
Operation
i. When the all cable connections are completed, switch on
with the "Power Switch" button on the top of the controller.
ii.
If the position of antenna was in home position, "Home
state light" will be solid on to show it is ready to use.
iii. If the position of antenna was not in home position, "Home
state light" might be flashing, and the antenna will be back
in home position within maximum 2 minutes. Then "Home
state light" will be solid on.
Operation
i. Once antenna and controller are communicated, you can
select & change the satellite as you want.
ii. Select the desired satellite using the "Up/Down" buttons,
then press the "OK" button to accept the setting.
iii. If you select wrong satellite, you could re-search target
satellite using the "Up/Down" button, then press the "OK"
button to accept the new setting.
Operation
i. After the satellite selection, "Home State" light will light off
and the LED light of the selected satellite will be flashing.
ii. Once selceted satellite found, the LED light of the satellite
become solid.