Firmware Update - SELFSAT SNIPE BT Grey Line Bedienungsanleitung

Power input cable
NOTE
※ USB 2.0 standard has to be only used for update
※ Use FAT32 format USB only
1. Transfer firmware program to a USB root folder (not belonging to any other folder) in an empty USB
i. Please go to website www.selfsat.com to download update program (firmware)
ii. In case a controller does not recognize the USB drive, take the USB out and plug into a PC.
Right click USB folder, go to "Properties" and check if the "File system" is FAT32.
If not, right click USB folder again, go to "Format" and re-setup a file system to FAT32
2. Ensure that the unit is turned off and plug the USB into USB port of controller
3. Press and hold SET button then turn on the power
4. During upgrade process, satellite LEDs are lit in sequence
For example :
5. Once update is completed, controller starts to reboot

6. Firmware Update

USB
ENGLISH - 13
CONTROLLER