Installing Accessories - Ferm SSM1005 Originalbetriebsanleitung

Mains connection
Only use earthed sockets with earthing wire connected per the regulations.
Replacing the mains connection cable
The mains connection cable may only be replaced by a special cable in a specialised workshop.
Replacing cables or plugs
Dispose of old cables or plugs immediately after replacing them. It is dangerous to connect the plug of a
loose cable to a wall socket.
Using extension cables
Only use an approved extension cable, corresponding to the machine power use. The wires must have
a minimum cross section of 1.5 mm

3. INSTALLING ACCESSORIES

Always disconnect the machine from the main power supply before carrying out any
maintenance work
Installing the protective cover
Fig.B
• Before commissioning the machine, the protective cover (5) must be installed.
• Insert the screw from the inside left, then affix the washer and the safety ring from the right side. The
safety ring (A) may be left out optionally.
• Screw the knurled nut in tight.
Installing the cross guide
Fig.C
The cross guide (3) allows material to be bevelled, and can be simultaneously used to support the
material as it is fed through the saw.
Mounting the rubber feet
Fig. G
The enclosed rubber feet contribute to a steady position of the scroll saw on your worktable
• Place the rubber foot on its place
• Connect the rubber foot with help of the enclosed bolt, ring and nut
• Tighten the nut with a wrench
Sawdust blower
Fig. H
The sawdust blower keeps the workpiece clean for more accurate scroll cuts. For best results, always
direct air flow from the blower tube at blade and workpiece. To adjust, simply bend to desired position.
Installation
• Place the sawdust blower on the hole on top of the machine
• Turn the blow pipe clockwise into the hole
Ferm
. If the cable is on a reel, it must be fully paid out.
2
EN
7