Assembly And Accessories - Ferm MSM1037 Originalbetriebsanleitung

against the stop and can't move, so it cannot
till or turn or move while sawing.
x) Never use the machine to saw pieces of work
that are to small that they cannot be secured
safely. Small pieces of wood or other objects
that come in contact with the rotating saw
blade can strike the operator or out standers
with high speed.
y) When sawing always use the additional
supports.
z) For sawing of large piece work that not
supported. Use extra supports.
aa) Never make warning signs on the machine
unrecognizable. Technical information or
machine type information must be always
visible on machine.
At the end of the sawing process, keep the saw
head downstairs, switch off the machine and
wait until the all moving parts has come to a stop
before you take your hands off the machine.
3. ASSEMbly And
ACCESSoRIES
Installation of the mitre saw
• P lace one sidebar (21) on the right-hand side
of the machine and the other sidebar on the
left-hand side of the machine.
• P lace the work piece clamp (7) on the left or
right side of the machine.
• H old the handgrip and move the saw slightly
downwards and then pull the pin (5) out slightly
so that saw moves upwards.
note: Never use the mitre saw without the
extension pieces supplied. Make sure that they
are correctly mounted.
Mounting the anti-tip over support.
• T he anti-tip over support (24) is pre mounted.
• A lways extend the anti-tip over support when
using the machine.
Sliding fence
Fig. 2
For safety reasons, this machine is equipped with
a moveable guide fence to used in normal and
bevel cutting.
• F or normal straight cross-cuts and mitre cuts,
always adjust the sliding fence (8)(12) to the
end and fix well to provide safety support for
work piece.
• F or bevel cuts, adjust the sliding fence (8)(12)
to a suitable position as close as to the saw
blade surface but avoid interfere the saw blade
movement and ensure to fix well.
Changing the saw blades
Fig. 4 and 5
Only use saw blades that are sharp and
undamaged. You must immediately
replace chipped or bent saw blades.
dAnGER: do not use any blade larger than the
stated capacity of the saw. It may come into
contact with the blade guard and cause harm.
Do not use a blade too thick to allow the outer
blade washer to engage with the flats on the
spindle. This will prevent the blade screw from
securing the blade on the spindle.
Do not use this saw to cut metal or masonry
• D isconnect the machine from the power supply.
• R emove the screw (19) that holds the retraction
arm(20).
• P ress the saw blade lock button (22) and hold.
Rotate the saw blade carefully by hand until the
blade locks.
• U se hex key to remove the saw blade bolt (17)
by loosening in a clockwise direction.
• L ift the blade cover (6) upwards using unlock
button (3) and hold it.
• R emove the Flange (18) and the saw blade.
• R eplace the saw blade making sure that the
arrow marked on the saw blade must point in
the same direction as the arrow shown marked
on the machine. The saw blade teeth must
point downwards.
• L ower the blade cover (6).
• R eplace Flange and fix the saw blade bolt (17)
use the saw blade lock button (22) to secure
tightly.
• A ttach the retraction arm (20) back by
tightening the screw (19).
• R otate the saw blade manually and check if the
guard operates freely.
9