Inhaltsverzeichnis
Werbung
CDF236
A
NOTICE! Damage hazard
• Check that the voltage specification on the data plate corresponds to
that of the energy supply.
• Only connect the cooling device to a DC power supply in the vehicle
with the DC cable.
• Never pull the plug out of the socket by the cable.
• Disconnect the cooling device and other power consuming devices
from the battery before connecting a quick charging device.
• Disconnect the cooling device or switch it off when you turn off the
engine. Otherwise you may discharge the battery.
• The cooling device is not suitable for transporting caustic materials or
materials containing solvents.
• The insulation of the cooling device contains flammable cyclopentane
and requires special disposal procedures. Deliver the cooling device
at the end of its life-cycle to an appropriate recycling center.
• Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for the purpose.
• Do not place the cooling device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
• Risk of overheating!
Ensure at all times that there is a minimum of 50 mm ventilation on all
four sides of the cooling device. Keep the ventilation area free of any
objects that could restrict the air flow to the cooling components.
Do not place the cooling device in closed compartments or areas with
none or minimal air flow.
• Ensure that the ventilation openings are not covered.
• Do not fill the inner container with ice or fluids.
• Never immerse the cooling device in water.
• Protect the cooling device and cables against heat and moisture.
• The device shall not to be exposed to rain.
EN
Safety instructions
15
Werbung
Inhaltsverzeichnis
