Configuration; Link Up Configurator App; Sensor Configuration - Veratron LINK UP Serie Bedienungsanleitung

CONFIGURATION

LINK UP CONFIGURATOR APP

To configure the sensor, some parameters must be calibrated through the LinkUp gateway, like sensor type,
engine instance or warning threshold.
This is possible through the "Link Up Configurator" smartphone App, which can be downloaded free of
charge from the stores of both Android and iOS devices.
A simple and detailed explanation of the configuration process is also available as in-app instructions.
Thanks to the passive embedded NFC receiver, the LinkUp gateway can be configured, as described below,
without the need of power supply.

SENSOR CONFIGURATION

LINK UP
CONFIGURATOR
1. Launch the "Link Up Configurator" App and read the
actual configuration of the LinkUp device by "tapping"
the smartphone onto the devices wireless area (indicated
by the red arrow).
NOTE: The antenna position on the smartphone
depends on the model.
Please refer to the smartphone manufacturer manual.
CONFIGURATION
B001032