System Installation; Before The Assembly - Veratron LINK UP Serie Bedienungsanleitung

SYSTEM INSTALLATION

Before beginning, disconnect the negative terminal on the battery, otherwise you risk a short circuit.
If the vehicle is supplied by auxiliary batteries, you must also disconnect the negative terminals on these
batteries! Short circuits can cause fires, battery explosions and damages to other electronic systems.
Please note that when you disconnect the battery, all volatile electronic memories lose their input values
and must be reprogrammed.

BEFORE THE ASSEMBLY

1. Before beginning, turn off the ignition
and remove the ignition key. If necessary,
remove the main circuit switch
2. Disconnect the negative terminal on the
battery. Make sure the battery cannot
unintentionally restart.
3. Place the device at least 300 mm away
from any magnetic compass.
WARNING
SYSTEM INSTALLATION
B001032