10 | Delete Setback Program; 10 | Temperature Calibration; 10 | Resetting The Heater; 10 | Memory Function - Mill AB-H1000MEC Bedienungsanleitung

10
Delete a setback program
Press and hold
for 3 seconds.
Temperature calibration
It may occur deviation between the temperature registered by the heater and the
actual temperature in the room. This can be caused by several reasons, however, the
most common is that the heater is placed in a fair distance from where you usually
reside. When you set the temperature to for example 22 degrees, it is only natural that
you expect the same temperature where your sofa is placed for instance. However,
the temperature sensor is placed on the product itself, and therefore a deviation in
temperature may occur. To adjust this, all Mill heaters are equipped with a calibration
function, which enables you to adjust the temperature registered by the heater. N.B!
The room must have achieved a stable temperature before any calibration.
Press
Resetting the heater
Turn off the heater's main switch. Press and hold
main switch.
Memory function
The heater remembers all the temperature settings and will automatically return to
the desired temperature after a power cut. Your day- and nighttime setbacks will
however be deleted after a power cut, and you will need to register the programs
again.
or (depending on which setback period you want to cancel)
2 times and use + or – to set the actual temper ature observed in the room.
while you turn on the heater's