Usage Mechanical Thermostat; Instructions Day/Night Thermostat - Mill AB-H1000MEC Bedienungsanleitung

6

Usage mechanical thermostat

1. Set the output selector to the OFF position (0) and the thermo stat to minimum.
Plug the heater into a grounded outlet.
2. Set the output selector to position |, || or |||. Turn the thermostat up to the maximum
position. When the desired room temperature has been reached, t urn the
thermostat slowly down until you hear a click. The thermostat can now remain in
this position until a different room temperature is desired. As soon as the room
temperature falls below this level, the heater will automatically switch on again.
When the room has again reached the desired temperature, the he ater will switch
off again.
3. If you wish to change the room temperature, repeat the instructions in step 2.
4. The heater has an overheat protection that turns the device off if any parts become
extremely hot.
To switch the heater off, turn the output selector to the O position. If the heater will
5.
be left unused for a longer period of time, pull out the plug.

Instructions day/night thermostat

Please see table on page 4 for which models that have day- and night thermostats
Control panel
1. Standby
2. Daytime setback
3. Nighttime setback
4. Power indicator — Shows whether the heater is using power or not
5. Desired room temperature
6,7, 8 Indicates the output level
9. Timer function
10. Daytime setback activation button
11. Nighttime setback activation button
12. Function button
13. Timer activation button
14. Thermostat and output selector:
i.
Turn the selector to the left to decrease the temperature, and turn the selector
to the right to increase the temperature.
ii. Push the button to change the desired power level. 3 power levels
WARNING!
INSTRUCTIONS BEFORE USING THE HEATER!
BE SURE THE FOOT IS FITTED CORRECTLY AND ACCORDING TO THE
If the temperature sensor is not functioning properly, you will see this
symbol on the display. Please contact the dealer or importer.