Color Codes (Wifi Control Light); Activating Wifi; Deactivating Wifi; Reconnecting Wifi - Mill SG1200WiFi Bedienungsanleitung

8

Color codes (WiFi control light)

(flash)
(flash)

Activating WiFi

See figure 7 on separate illustration sheet
Press «add heater» on the home screen in the Millheat-app. Follow the
instructions in the app.
Dectivating WiFi
See figure 8 on separate illustration sheet
Press 1 time on the WiFi button. The heater can now be used as described on
page 6 (usage without WiFi connection). Relevant only if WiFi is already installed.

Reconnecting WiFi

See figure 9 on separate illustration sheet
Press the WiFi button 1 time. Relevant only if WiFi is already installed.
Delete WiFi setting
See figure 10 on separate illustration sheet
Delete WiFi-settings: Press and hold WiFi button for 3 seconds.
The heater can also be reset to the factory settings by doing the following:
Turn o the heater's main switch. Press and hold
heater's main switch.
The heater has not been connected to WiFi. The heater keeps an even
temperature throughout the whole day and night.
The heater is online in the Millheat cloud.
1. The heater's WiFi is deactivated by the user.
2. When installing/connecting the Millheat-app and cloud, the light will flash
in various speed. This is normal.
The heater has a problem connecting to or finding the WiFi signal. Please do
the following:
1. Please turn the heater OFF and ON again.
2. Please restart the WiFi router.
3. Please check the WiFI router to make sure the capacity is su cient for the
number of active devices connected at the same time.
4. Please make sure 2,4 Ghz is activated. If the problem persists we
recommend you to deactivate 5 Ghz during the installation. A er the
installation 5 Ghz can be activated again.
The heaters are o ine and have no contact with the Millheat cloud.
while you switch on the
WiFi