Color Codes (Wifi Control Light); Activating Wifi; Deactivating Wifi; Reconnecting Wifi - Mill OIL2000WIFI3 Montageanleitung

8

Color codes (WiFi control light)

Activating WiFi

Press «add heater» on the home screen in the Millheat-app. Follow the
instructions in the app.

Deactivating WiFi

Press 1 time on the WiFi button. The heater can now be used as described on
page 6 (usage without WiFi connection). Relevant only if WiFi is already installed.

Reconnecting WiFi

Press the WiFi button 1 time. Relevant only if WiFi is already installed.
Delete WiFi setting
Delete WiFi settings: Press and hold WiFi button for 5 seconds.
The heater can also be reset to the factory settings by doing the following:
Turn the heater back on, within 5 seconds press and hold
The heater has not been connected to WiFi. The heater keeps an even
temperature throughout the whole day and night
The heater is online in the Millheat cloud
The heater's WiFi is deactivated by the user
When installing/connecting the Millheat-app and cloud, the light will
flash in various speed. This is normal.
The heater has a problem connecting to or finding the WiFi signal. Please
do the following:
1. Please turn the heater OFF and ON again.
2. Please restart the WiFi router
3. Please check the WiFi router to make sure the capacity is su cient for
the number of active devices connected at the same time
4. Please make sure 2,4 Ghz is activated. If the problem persists, please
get in touch with support.
The heaters are o ine and have no contact with the Millheat cloud
for 5 seconds.