Usage Day/Night Thermostat; Timer Function; Day- And Nighttime Setback - Mill AB-H1000MEC Bedienungsanleitung

millnorway.com

Usage day/night thermostat

1. Plug the heater into a grounded outlet.
2. Press OFF/ON button.
3. Choose the desired power |, || or |||, by pressing the output selector. Turn the
thermostat to the desired temperature while looking at the di splay. As soon as the
room temperature drops below this level, the heater will automatically start again.
When the room has reached the desired temperature again, the he ater will turn
4. The thermostat goes from 5 to 35°C.
5. If you want to change the temperature in the room, repeat step 3.
6.
The heater has an overheat protection that turns the device off if any parts become
extremely hot.
7. To turn off the heater, press the OFF/ON button. Should the heater be left unused
for a longer period of time, pull out the plug.

Timer function

Day- and nighttime setback

When programming the heater for either day- or nighttime setback, the setback
period will be active from the time you register the program . Which means; if you want
to start your daytime setback at 7.30 am, you need to register the program at 7.30 am.
You only need to program the heater 1 time for daytime setback and 1 time for
nighttime setback. If you have programmed the heater, the setback programs will be
active on the following days:
Daytime setback: Monday-Friday (day 1-5)
Nightime setback: All nights
EXAMPLE:
Let us say you want to program the heater for both daytime- and nighttime setback
(normally the heater is set to 23 degrees). You want the heater to do the following:
1. Daytime setback activated from 7.30 am to 2.30 pm. Desired temperature: 17
degrees
2. Nighttime setback activated from 10.00 pm to 6.00 am. Desired temperature: 18
degrees
r of hours have passed.
7