Constant-Electronic; 1800 - 3800 Min; Symbols; Tool Specifi Cations - Protool CSP 68-2 EB Originalbetriebsanleitung

Hand Circular Saw CSP 68-2 EB
- original instruction
Table of contents
1 Symbols ................................... 14
2 Tool Specifi cations ...................... 14
3 Operating Controls ..................... 14
4 Intended Use ............................. 15
5 Notes on Safety Prevention ......... 15
5.1 General Safety Instructions ......... 15
5.2 Safety Rules for Circular Saws ..... 15
5.3 Additional Safety Rules
for all Circular Saws ................... 15
5.4 Specifi c Safety Rules
for CSP 68-2 EB Circular Saws ..... 16
5.5 Emission levels .......................... 17
6 Commissioning and Operation ...... 17
7 Adjustment ............................... 18
7.1 Electronic Motor Control .............. 18
7.2 Cutting Depth Adjustment ........... 18
7.3 Cutting Angle Adjustment ........... 18
7.4 Cutting Edge Indicator ................ 18
7.5 Parallel Guide ............................ 18
7.6 Exhaustion ................................ 19
7.7 Replacing the Saw Blade ............. 19
8 Operating Instructions ................ 19
9 Use of Accessories ..................... 20
10 Maintenance .............................. 20
11 Environmental Protection/
Disposal.................................... 21
12 Warranty .................................. 21
13 Declaration of Conformity ............ 21
1

Symbols

Double insulation
Warning of general danger
Risk of electric shock
Wear ear protection!
Wear a dust mask!
Use protective gloves!
Read the instructions
Not to be included in municipal refuse
Advice or tip
►
14
GB
2

Tool Specifi cations

Nominal voltage
Mains frequency
Power consumption
Rated rpm (no load)
Speed pre-selection

Constant-Electronic

Run-on Brake
Starting current limiting
Spindle locking button
Saw blade Diameter
Hole
Tooth width
Blade thickness
Cutting depth 90°
45°
Cutting angle
Weight (without accessories)
Protection class
3

Operating Controls

[1-1] Lock-off switch
[1-2] On/Off switch
[1-3] Spindle locking button
[1-4] Sawdust ejector
[1-5] Riving knife screw
[1-6] Lever for swinging guard
[1-7] Base plate
[1-8] Swinging protective guard
[1-9] Parallel guide
[1-10] Additional holder with lever
[1-11] Speed control
[1-12] Handscrew
[2-1] Allen key
[2-2] Clamping screw
[2-3] Clamping fl ange
[2-4] Saw blade
[2-5] Mounting fl ange
[2-6] Riving knife
[2-7] Motor spindle
[3-1] Clamping lever for cutting depth set-
ting
[3-2] Cutting depth scale
[4-1] Cutting edge indicator
230 V ~
50 / 60 Hz
1600 W

1800 - 3800 min

-1
•
•
•
•
•
190 mm
30 mm
2.6 mm
1.6 mm
0 ... 68 mm
0 ... 50 mm
90° ... 45°
6.1 kg
II /