Acceleration Rate Setting; Deceleration Rate Setting; Programs; Saving Programs - OHAUS Frontier 2000 Serie Handbuch

EN-8

3.3.5 Acceleration rate setting

Press the "SET" button until a flashing "8" is displayed in the Acc window. Use the " " or " " buttons to adjust
the value by 1 gear each time you press. The range of acceleration rate is 0- 9 gears. The acceleration rate of
gear 0 is the slowest while the rate of gear 9 is the fastest. The higher the value, the faster the acceleration rate.

3.3.6 Deceleration rate setting

Press the "SET" button until a flashing "8" is displayed in the Dec window. Use the " " or " " buttons to adjust
the value by 1 gear each time you press. The range of deceleration rate is 0 - 9 gears. The deceleration rate of
gear 0 is the slowest while the rate of gear 9 is the fastest. The higher the value, the faster the deceleration rate.
The figure below shows the acceleration rate at the gear 3 and the deceleration rate at gear 6.

3.4 Programs

3.4.1 Saving programs

You can save at most 9 sets of A-L3 programs, including operating parameters and the rotors used. Of these,
A/B/C/D/E/F/G are single-step operating programs, H1-H2 are dual-step programs, and L1-L2-L3 are triple-
step programs.
After installing the rotor, press the "Prog" button to select the program number that needs to be set. After
setting the rotor number and operating parameters, wait for approximately 3 seconds and the set parameters
will be automatically saved to the current program number.
3.4.2 Calling programs
Press the "Prog" button to select a pre-set program number (as shown at M1 in the Figure). The saved
operating parameters will be displayed automatically.
Figure.14
Figure.15
Figure.16
TM
Frontier 2000 Series Centrifuge