Hacker HST-120 Betriebsanleitung Seite 40

Mounting and commissioning
Operating the controller without the user interface
Prerequisite for the operation of the controller WITHOUT the user interface is the previous configu-
ration of the controller. This can only be done via the user interface.
After you have decided on an appropriate controller input, you must connect it on the hardware
side via a plug connection (see point 2.1) and then define and configure it in the GUI in the Confi-
guration/Control/Control application menu item (see point 6.4). The menu navigation is completely
intuitive and self-explanatory.
The figure shows the setting using the example for the PPM input in connection with the current control.
We are also happy to support you with the commissioning and setup of your application.
Other
Graph function
A very practical graph function is also integrated in the scope of functions of the user interface.
This allows a live observation of the parameters over time. You can access this function via the
„Graph" tab. There you have to click the check box „Activate graph" to start the display. You can
monitor the parameters like setpoint, voltage, current, temperature.
Page 40 of 45
Brushless DC Controller HST-120
Orginal operating manual Rev1.3