Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
After you have successfully connected the controller and put it into operation, you can control
the motor via the GUI. To do this, first press the Start Control button, the screen shown above
should then appear.
•
Now check the current configuration of the system. To do this, go to the „Configuration" / „Cont-
rol" / „General" tab and press the „Read Config" button.
•
Make sure that under „Control application"
the item CAN1 is marked, if not, mark it and
then press „Write config". Now the system
can be controlled completely via CAN bus.
Then switch from the „Control" submenu to
the „Motor" menu and press „Read Config"
as well.
Brushless DC Controller HST-120
Orginal operating manual
Mounting and commissioning
As a rule, we have already imported a configu-
ration file for you. If not, you can import it into
the controller via „Open Config" and then „Write
Config". Check the correctness of the imported
data with the „Read Config" command. The
system is now ready for operation.
Page 38 of 45
Rev1.3
Werbung
Inhaltsverzeichnis
