Hacker HST-120 Betriebsanleitung Seite 41

Using the USB interface
Basically you have the possibility to use the whole functionality of the user
interface via USB. To do this, connect the controller to your computer using
a suitable USB cable and install the driver (Virtual Com Port) (can be re-
quested via his@hacker-motor.com). Now select the appropriate COM
port and press „Connect". Then continue as described in 6.4.
NOTE
Changing parameters
Changing the parameters requires sound specialist knowledge. Incorrect parameters
can lead to the destruction of the drive and cause consequential damage.
If you are not sure about the tuning of your drive, contact our industrial depart-
ment:
his@hacker-motor.com
Accessories
To be able to use the extended range of functions, you may need
additional connectors. According to point 2, 4-pole and 5-pole plugs
are used on the HST-120 controller to control the different interfaces.
These socket housings and the matching crimp contacts with cable
can be purchased separately.
Brushless DC Controller HST-120
Orginal operating manual
Mounting and commissioning
Page 41 of 45
Rev1.3