Hacker HST-120 Betriebsanleitung Seite 37

GUI user interfaces
NOTE
The commissioning procedure documented below is shown using the HerSi-Can ad-
apter as an example. The procedure for the Peak Adapter is analogous.
• Plug the HerSi-Can adapter into a free USB slot and install the driver if necessary (can be re-
quested via his@hacker-motor.com). If everything is installed correctly, a green LED lights up
on the adapter.
• Now open the GUI (can be requested via his@hacker-motor.com), you should see the follo-
wing user interface
• Now connect to the controller by first selecting the adapter you want to connect to in the upper
right corner, here HCan (HerSi-Can) and click on the „Connect" button. Now an additional oran-
ge LED should light up on the adapter.
• To check the correct connection to the controller, press „Scan". The GUI should now confirm
the connection to the controller with „Found devices: 1" and display the ID. The green dot next
to „Founde devices" should light up statically.
• The controller is now ready for operation
Brushless DC Controller HST-120
Orginal operating manual
Note
We strongly recommend that you commission the drive
unit on a separate test bench and check it for correct func-
tioning before installing it in the application.
Mounting and commissioning
Page 37 of 45
Rev1.3